Terminal crimping terminal machine of commonly used in the operation, it has very strict technical standards, mainly including: pulled off force size, symmetry, line pressure meet in the middle of the both sides have a bell mouth, wire core pressure it without aperture, bottom can't pressure Angle, etc.

1. Purpose:

- check the base member for terminal image.

- visual inspection method is applicable.

- not sure about the ambiguity.

- reproducibility of measurement (determination experiment) is not suitable.

2. Problem points (projects):

- there is no reference component for bellMouth.

- section status check benchmark components.

1)FLASH is too large and FLASH biased.

2) void fraction.

3)BARREL asymmetry.

4)BARRELSIZE due to excessive interference (bottom, side)

3. The countermeasures:

- set inspection standards and protocols for each project.

- increase the set inspection benchmark for joint use.

- applicable relevant data (TEST related data)

4. Add the setting benchmark:

-bellmouth has, no benchmark setting append benchmark.

- additional setting of inspection datum of section status.

1)FLASH is too large and FLASH biased.

2) void fraction.

3)BARREL asymmetry.

4)BARRELSIZE interferes (bottom, side) due to excessive size